• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

Wiki Is there a CPT code for smoothing out rough edges of calcaneus?

Create Wiki
D

depaul

Contributor
Messages
13
Location
Colorado Springs, CO
Best answers
0
Provider first did a plantar fasciectomy, op note in part states " After the plantar fascia was released, the plantar calcaneus was inspected and found to not have a significant bone spur needing resection. However, rough areas of the edge of the plantar calcaneus were smoothened out with a reciprocating bone rasp." We were looking at 28119, but do not feel that is correct since code indicates "for spur". Any thoughts on a CPT code to use?
 
Applicable CPT Codes
  • CPT 28119: Use this code if the surgeon excised a bona fide calcaneal spur, regardless of whether or not a plantar fascial release was also performed. Smoothing the edges with a bone rasp is a standard component of this procedure. [1, 2, 3]
  • CPT 28118: Use this code if the surgeon removed a piece of the calcaneus (ostectomy) for conditions other than a definitive spur (such as bone bossing), or if no actual spur was identified/eliminated. [1]
  • CPT 28120: Use this code if the surgeon performed a partial excision (craterization or saucerization) of the calcaneus. [1, 2]

Coding Rules to Keep in Mind
 
You must log in or register to reply here.
Top