• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

Wiki Need help!

JenReyn99

Guru
Messages
142
Location
Redding, CA
Best answers
0
Here's the note:
.....a transverse incision was made over the marked side of the bulge in the abdominal wall. Eventration of mesh into an old hernia sac was noted without actual herniation or recurrence. As the mesh was a bit redundant in that location, it was imbricated back into the peritoneal cavity with far-near/near-far Prolene sutures....

This is what I have to code from. I'm not sure what direction I should go. I guess I could go with an exploratory laporotomy, but I'm not sure I like that. Any ideas? They were going in because they thought the pt. had a recurrent abdominal wall hernia. Any help is appreciated!
 
Here's the note:
.....a transverse incision was made over the marked side of the bulge in the abdominal wall. Eventration of mesh into an old hernia sac was noted without actual herniation or recurrence. As the mesh was a bit redundant in that location, it was imbricated back into the peritoneal cavity with far-near/near-far Prolene sutures....

This is what I have to code from. I'm not sure what direction I should go. I guess I could go with an exploratory laporotomy, but I'm not sure I like that. Any ideas? They were going in because they thought the pt. had a recurrent abdominal wall hernia. Any help is appreciated!

This would still qualify as a repair of a recurrent hernia. The mesh from the previous repair was intruding into the old hernia sac, they had to push it back in and resew the mesh to hold it in. You didn't state the actual location of the hernia, but I assume it was either ventral or incisional since those are the ones they typically use mesh for.
 
Top