• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

3rd degree burns

S

SANDYB42012

Contributor
Messages
15
Location
Phoenix, Arizona
I have a pt with 3rd degree burns tx general anes Xenograft applied to burns on face, chest, arms, hands, and legs. Dr didn't provide any measurements. Should I just code 15271 along with 3 hours of time?
 
15271 has no time, so no you wouldn't bill that with 3 hours. if you're talking about billing for the anesthesia services, then you shouldn't be using 15271 that way either, because that's a surgery code. when billing anesthesia you should use the anesthesia code that corresponds to the primary procedure being performed. for this case it would probably be 01952 and then 01953 if applicable.
 
You must log in or register to reply here.
Top