• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

Wiki Biomesh implant @ stoma construction CPT code needed

nlbarnes

Expert
Messages
292
Location
Escondido, CA
Best answers
0
My plan now was to place a biologic mesh to try to prevent a parastomal hernia as
this patient will have a permanent colostomy. We were right up and
just below the level of the arcuate line, so there was really no
posterior rectus fascia for me to takedown; however, I entered the
plane between the peritoneum and the posterior aspect of the rectus
abdominis muscle. I opened up the spleen widely going at least 3 cm
beyond where my hole for my ostomy was. I then cut an 8 x 8 cm piece
of the stratus that Dr. P was already planning to use, soaked it
bacitracin ointment and then sewed it into the sublay plane that I
created using interrupted 3-0 Vicryl suture. I then identified the
hole in the peritoneum for the ostomy and used an 11 blade to open the
mesh at this point and then extended my mesh incision to make a
cruciate type incision just large enough to allow passage of the
ostomy through and this left the tails of the mesh at the cruciate
keyhole sitting up against the sides of the bowel. I of course did
not sew them in place there. They just rested there. I then passed
the bowel back through the peritoneum and the mesh and then through
the rectus muscle and anterior fascia and off the skin as I had before
and I sewed the mesh all along the edge of the peritoneum with a
running 0 Vicryl suture.
 
Top