allan_pruna@yahoo.com
Guest
- Messages
- 8
- Best answers
- 0
What code should I use to report the removal of a fishhook in the little finger using a forcep?
-
If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten your username or password use our password reminder tool. To start viewing messages, select the forum that you want to visit from the selection below..
Wiki CPT Code for removal of fishhook in finger using a forcep.
- Thread starter allan_pruna@yahoo.com
- Start date
sswisher
Guest
If the provider removed the hook with forceps and made a small incision to free the barb, then it is 10120. Otherwise, just bill an e/m (and code a 64550 if digital block performed).
FB removal is separately codable procedure only if an incision was made. In that case the code would be a 10120. Incision length and incising tool are not specified. The tool need not be a scalpel. For example, the sharpened bevel of an 18 gauge needle could be used to incise around the barb and that would count for 10120. 64450 is not separately billable if 10120 is coded.
FB removal is separately codable procedure only if an incision was made. In that case the code would be a 10120. Incision length and incising tool are not specified. The tool need not be a scalpel. For example, the sharpened bevel of an 18 gauge needle could be used to incise around the barb and that would count for 10120. 64450 is not separately billable if 10120 is coded.
allan_pruna@yahoo.com
Guest
- Messages
- 8
- Best answers
- 0
I see, that's very clear. Thanks! 