• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

REVISION OF SPINAL INSTRUMENTATION ( RODS)

B

boyett

Networker
Messages
42
hello fellow coders,

i have a question and need advise on a case we have . my patient had a posterior fusion with rods from t8 to s1. later on after the procedure was performed the patient had a complication with the rod being to long. we then took the patient back to the operative room and cut the rods down to the correct size. the rod was not taken out it was cut down with bolt cutters. does anyone know a direction i need to go to obtain the correct code? thank you all in advance.
 
You must log in or register to reply here.
Top