• If this is your first visit, be sure to check out the FAQ & read the forum rules. To view all forums, post or create a new thread, you must be an AAPC Member. If you are a member and have already registered for member area and forum access, you can log in by clicking here. If you've forgotten the password it can be reset on our sign in section by entering your registered Email Address or Username here. To start viewing messages, select the forum that you want to visit from the selection below..

Wiki Microdiscectomy

coderguy1939

Guest
Messages
643
Best answers
0
Doctor performed lumbar microdiscectomy (63030) and used EMG neurovision intraoperatively. This involved rental of expensive equipment and I am not finding any reference to it in the body of the op report. Are there any words I should be keying into in the report that would document use of this machine? Thanks.

Op report says "S1 and L5 nerves were stimulated individually and both received a reading of less than 5, thus recording the normal range". I'm looking at 95904.
 
Last edited:
Correct...

Some procedures (e.g., intracranial, spinal) utilize intraoperative neurophysiology testing. Intraoperative neurophysiology testing (CPT code 95920) should not be reported by the physician performing an operative procedure since it is included in the global package. The physician performing an operative procedure should not report other 90000 neurophysiology testing codes for intraoperative neurophysiology testing (e.g., CPT codes 92585, 95822, 95860, 95861, 95867, 95868, 95870, 95900, 95904, 95925-95937) since they are also included in the global package. However, when performed by a different physician during the procedure, intraoperative neurophysiology testing is separately reportable by the second physician.

http://www.cms.hhs.gov/NationalCorrectCodInitEd/01_overview.asp#TopOfPage
 
Top